Final Checklist - Fulgor Milano Sofia Instructions D'installation

To prevent improper connections leading to damage
of electrical components and so voiding the warranty,
the following steps must be performed:
1. Check the electrical requirements and make sure
you have the correct electrical supply and that the
range is properly grounded.
2. Turn on the power supply to the range.
3. Check power at the junction box wires using a
voltmeter having a range of 0-250 VAC. If you
have installed the oven for use on 240 Volt
VXSSO\ \RX VKRXOG ¿QG WKDW WKH YROWDJH UHDGLQJ
between the black and red wires (Line to Line)
VKRXOG EH  WR  9ROWV ,I \RX KDYH PRGL¿HG
the range(s) for use on 208 Volt, the voltage
reading between the black and red wires should
be 190 to 208 Volts.
4. Set the clock by following these steps:
• Press [TIME] key twice until the display shows
"SET TIME".
• Immediately press [INC] or DEC] keys to set
hours.
• Press [TIME] key again to change minutes.
• Immediately press [INC] or DEC] keys to set
minutes, hold to change by ten (10) minutes
step.
• Press [TIME] key or wait for a few seconds.
Clock is now set.
5. Test the bake mode by following this step:
• Move cooking mode knob to "BAKE" position.
• Cooling fan, oven lights, preheat led will turn on.
• A beep is sounded when the oven reaches the
preset 350 °F (175 °C) and the preheat light turn
R 
• Move the knob back to "OFF" position to stop
cooking.
6. To check the other oven functions refer to the
"Using the Oven Controls" section of the USE
AND CARE MANUAL.
 ,I WKH RYHQ LV ZRUNLQJ SURSHUO\ WXUQ R WKH SRZHU
supply to the oven.
8. Place the cover on the junction box and make
sure the cover is securely fastened and turn on
the power to the oven.
Leave these INSTALLATION instructions as well
as the USE AND CARE MANUAL with the owner.
14

Final checklist

CONNECTING TO 208 VOLT CIRCUIT
This option is provided for areas where standard
240 Volt service is not available. This option must
be accessed with the appliance connected to power
source, and using the following sequence:
 :LWKLQ ¿YH PLQXWHV IURP SRZHU XS KROG
[OPTIONS] and [TIME] keys for 3 seconds to
enter the user option menu. The display shows
as follows:
2. Hold then [TIME] and [LIGHT] keys until the
display becomes dark.
3. Hold [OPTIONS] and [LIGHT] further, until the
time display shows "Volt" and temperature
module shows "240" blinking, waiting for an input.
4. Using [INC] or [DEC] keys, the control toggles
between
³237,216´ WR FRQ¿UP
5. Hold [TIME] and [LIGHT] keys in order to quit the
selection.
6. Hold [OPTIONS] key for 3 seconds to quit the
user option menu.
The voltage setting is stored and kept even after a
ORQJ SRZHUR 
Installation Manual
240V and 208V options.
ENGLISH
Hold