Fulgor Milano Sofia Instructions D'installation page 15

to see the appropriate connection type)
3) Connect line 1 (black) and line 2 (red) wires to the
outer terminal block posts with 10-32 hex nuts.
4) Securely tighten hex nuts.
5) Replace terminal block access cover.
A
C
F
A. Terminal block
B. ground strap
C. L1 Black wire
D. L2 Red wire
E. Neutral White wire
F. Ground Link screw
Direct Electrical Connection to the Circuit
%UHDNHU )XVH %R[ RU -XQFWLRQ %R[
If the appliance is connected directly to the circuit
EUHDNHU IXVH ER[ RU MXQFWLRQ ER[ XVH ÀH[LEOH
armored or non metallic sheathed copper cable (with
grounding wire).
3-WIRE BRANCH CIRCUIT (for US only)
Refer to Figure A:
where local codes allow the connection of GROUND
wire from the range to the branch circuit NEUTRAL
wire (gray or white colored wire):
- If local codes permit, connect the green GROUND
wire from the range and the white wire from the
oven to the branch circuit NEUTRAL wire (gray or
white colored wire).
- Connect the red and black leads from the range
to the corresponding leads in the junction box.
E
D
B
4-WIRE BRANCH CIRCUIT (for US only)
Refer to Figure B:
- Disconnect ground from neutral at free end of
conduit.
- Connect the green GROUND wire from the range
to the GROUND wire in the junction box (bare or
green colored wire).
- Connect the red and black leads from the range
to the corresponding leads in the junction box.
- Connect the white wire from the range to the
NEUTRAL (gray or white) wire in the junction box.
'2 127 JURXQG WR D JDV VXSSO\ SLSH DO NOT
connect to electrical power supply until appliance
is permanently grounded. Connect the ground wire
before turning on the power.
A
Grounded Neutral
Junction box
power supply
Red wires
White wires
Bare or
green wire
Cable
from oven
B
Ungrounded Neutral
Junction box
power supply
Red wires
Bare or
green wire
from oven
Installation Manual
ENGLISH
Cable from
Black wires
UL listed conduit
connector
Cable from
White wires
Black wires
Cable
UL listed conduit
connector
13