Installation
Installation with the mounting bracket
1. Ensure the location is sufficient for this panel
heater to be used.
2 Use the supplied screws (M4x32) and anchors
if needed and attach the mounting bracket to
the wall, desk or table
3 Slide the heater into to the mounting bracket
4 Turn the unit ON and select the setting to be
used (Refer to Operation)
※ Important Note: If placing under a desk or table
to ensure that it can hold the weight of this heater.
Cleaning and Maintenance
• Unplug the unit and let it cool down before cleaning. Wipe the unit with a soft wet cloth.
Do not use solvents or abrasives.
• Allow sufficient drying time before turning the unit on again
• To prevent damage, don't scrape the heater or coils with any sharp instruments
• If not used for an extended period of use, it is recommended that the unit be cleaned and packed
in the original box and stored in a cool, dry place.
Specifications
Model
Voltage
Input power
Dimensions (W x D x H)
Weight
(Continued)
RPH-260G
AC 120 V, 50 / 60 Hz
High : 260 W, Low : 130 W
20.6" x 15.2" x 1.1" (522 x 385 x 28mm)
5 lbs (2.3 kg)
1
3
2
4
6