Working On The Device; Service Notes - Laserworld Purelight Série Mode D'emploi

Masquer les pouces Voir aussi pour Purelight Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Manual: Laserworld Purelight Series
le, do not use the laser projector together
with large appliances (especially fog ma-
chines) on the same mains!
12. Ensure sufficient ventilation and do not
place the device on any warm or heat ra-
diating surface. Especially the ventilati-
on openings must not be covered!

4. Working on the device

1. This product has no user serviceable parts inside and should
only be maintained and serviced by a qualified engineer.
2. Be sure that the mains plug is not connected to the pow-
er supply while installing the device.
3. Take off all reflecting things like rings, watches etc. be-
fore starting to work with or at the projector.
4. Only use non-reflecting tools to work on device. Wear pro-
tective clothing (like goggles, gloves etc.) according to laser power and
wavelength of the laser.

5. Service notes

Moisture and heat can reduce lifetime of
the laser system dramatically and expires
any warranty claim.
Quick on/off switching of this device will
reduce durability of the laser diode dra-
matically.
Avoid sharp knocks and shocks to this
device and ensure sufficient protection
during transportation. Look after your La-
serworld product.
To increase durability of your laser,
protect device against overheating:
Always ensure sufficient ventilation.
-
Do not face spotlights (especially mo-
-
ving heads) to the device.
Check temperature after approx. 30
-
minutes with each new installation.
If necessary install the projector at a
page 6 / 69
13. Ensure that device does not get over-
heated. Make sure that the device is not
exposed to spotlights (especially moving
heads). Heat of spotlights could overheat
laser in a little while and leads to a degra-
dation of performance.
place with different temperature.
Keep the device dry. Protect it from
-
moisture, rain and damp.
Switch off device when it is not nee-
-
ded. Diodes are switched on and can
wear out even if there is no visible la-
ser output.
Removal of the warranty label as well
as damages to the device caused by
improper handling, neglect of the sa-
fety instructions and service notes will
void the warranty.
English

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Purelight pl-4500rgbPurelight pl-6000rgbPurelight pl-10.000rgbPurelight pl-20.000rgbPurelight pl-30.000rgbPurelight pl-6.000g ... Afficher tout

Table des Matières