Samson Synth Six Serie Mode D'emploi page 8

Guided Tour - UT6 Beltpack Transmitter
9: Group selector - Use the supplied plastic screwdriver to set this to the desired transmission
frequency Group.
10: Channel selector - Use the supplied plastic screwdriver to set this to the desired Channel. When
two or more transmitters and receivers are being used in the same location, they should be set up to use
different Channels within the same Group.—see the "Setting Up and Using the Synth Series 6 System"
section on page 10 and Appendix A on page 57 in this manual for more information.
11: Unavailable LED - This LED lights when transmission is impossible using the currently selected
transmitter Group and Channel (as determined by the Group and Channel selectors—see #9 and #10
above). If lit, it is an indication that you must choose a different Group and/or Channel for both the UT6
and the UR6D receiver.
12: RF power switch - Use this to select the UT6 RF power output. For normal operation, use the
10 mW setting (in this mode, up to 22 channels can be used simultaneously in the same location).
The 1mW setting provides less interference when the system is being used in a confined area and also
allows more channels (up to 96) to be used simultaneously in a single location. For more information,
see the "Samson Low Power Technique" section on page 14 in this manual.
13: Power on-off switch* - Use this to turn the UT6 on or off (to conserve battery power, be sure to
leave it off when not in use).
14: Battery holder - Insert two standard AA alkaline batteries here, being sure to observe the plus and
minus polarity markings shown. Springs hold the batteries securely in place, so you may need to pull
quite hard to remove them.
15: Plastic screwdriver - Specially designed for use in setting the Group and Channel selectors
(see #9 and #10 above) and for adjusting the Mic and Instrument level trimpots (see #6 and #8 on the
previous page). See the "Setting Up and Using the Synth Series 6 System" section on page 10 in this
manual for more information.
SAMSON
WIRELESS TRANSMITTER
FCC ID CCRUH6
dbx
NOISE
REDUCTION
* Be sure to mute the audio signal at your external mixer or amplifier before turning transmitter power
on or off, or an audible pop may result.
UT6
SAMSON
Technologies Corp.
Noise reduction manufactured under licence
from THAT Corporation. dbx is a registered
trademark of Carillon Electronics Corporation.
16: Belt clip - Use this clip to fasten the UT6 to a belt. The
position of the clip can be rotated to the desired position after
loosening its center screw or can be removed entirely by
removing the center screw.
16
8