Functional Description - SELFSAT SNIPE DOME Manuel Utilisateur

3-2. Functional Description

A. Power On
Function
B. Selecting the satellite
Function
C. Searching the satellite
Function
8
Description
"Power" Switch
"Stand by"
Light Solid ON
"Stand by"
Light Solid ON
Solid ON
Description
"Satellite
Up / Down button" Light
"OK" Button
Description
"Satellite" light
Operation
i. When the all cable connections are completed, switch on
with the "Power Switch" button on the top of the controller.
ii.
If the position of antenna was in Basic position, "STAND BY
state light" will be solid on to show it is STAND BY to use.
iii. If the position of antenna was not in the Basic position,
"STAND BY state light" will flash, and the antenna will return
to the Basic position within a maximum 2 minutes. Then
"STAND BY state light" will be solid on.
Operation
i. Once antenna and controller are connected, you can select
& change the satellite as you require.
ii. Select the desired satellite using the "Up/Down" buttons,
then press the "OK" button to accept the setting.
iii. If you select the wrong satellite, you can re-search target
satellite using the "Up/Down" button, then press the "OK"
button to accept the new setting.
Operation
i. After the satellite selection, "Stand by State" light will go off
and the LED light of the selected satellite will start flashing.
ii. Once selected satellite has been found, the LED light of the
satellite will become solid.