Technical Data - CTEK MULTI US 7002 Mode D'emploi

TECHNICAL DATA

Model
Voltage AC
Current
Back Current Drain*
Charging Voltage
Ripple**
Charging Current
Battery cable fuse
Ambient Temperature
Cooling
Charge cycle
Type of batteries
Battery Capacity
CEC-400 Battery capacity
Dimensions
Insulation
Warrany
Weight
*) Back Current Drain is what the charger uses to drain the battery if the power cord is
disconnected. The reverse current of the MULTI US 7002 is very low and corresponds to
1Ah per month.
**) The ripple wave describes how many disturbances are exhibited by current and voltage.
A rippled voltage can cause damage to other equipment connected to the battery. The
MULTI US 7002 supplies voltage and current with very low voltage rippling. This increases
the life of the battery and ensures that equipment connected to it will not be damaged.
BATTERY CABLES
MULTI US 7002 is equipped with a set of battery cables with battery terminal clips and
one set of battery cables with eyelet terminals. Do not shorten the battery cables.
Connecting the provided cables with eyelet terminals
Make sure that the cable is not pinched or in contact with warm surfaces or sharp edges.
When the cable is mounted on the battery, it should not be connected to the charger.
Connect the eyelet terminals to the battery's poles - the red cable to the positive pole and
the black cable to the negative pole. After this, the quick connector can be connected.
1018
100–115VAC, 50–60Hz. Output power is reduced at
lower input voltage.
2.0A rms
< 3mA
Nominal: 12V or 15.7V
Max 150mV rms, max 0.3A
7A max
15A
-4°F to +122°F. Automatic reduction of power at increased
ambient temperature.
Natural convection. Do not cover the charger.
MULTI US 7002 is a multistage fully automatic charger.
All types of lead-acid batteries (Wet, Maintenance Free,
AGM and most GEL).
14–150Ah
55–150Ah
8 / x 3 / x 1 / inches (L x W x H)
1 1 7
2 2 8
Raintight.
5 years
1.7 lbs
US • 13