Using The Lcd Monitor; Switching On The Monitor - Dometic PERFECTVIEW M71L Instructions De Montage

PerfectView M71L
I
NOTE
Observe the power consumption of the video system. The cameras are equipped with
heaters. A maximum current of 1.5 A can flow (three cameras in heating mode). Use a
disconnecter switch for direct connection to the battery. This allows you to disconnect
the video system from the battery easily if you are no longer using the vehicle.
Connecting an additional reversing camera (trailer operation)
➤ If necessary, connect socket AV4 (12) of the connection cable to the plug of the additional
reversing camera.
7

Using the LCD monitor

7.1

Switching on the monitor

➤ If the monitor is switched off, press the
➤ The button lights up blue.
✓ The picture appears.
7.2 Switching off the monitor
➤ Press the
button (fig. 0 2, page 6) to switch off the monitor.
➤ The button lights up red.
✓ The picture disappears.
7.3 Setting the monitor
To set the monitor to suit your requirements, proceed as follows (fig. 0, page 6):
➤ Press the "
" button (5) to call up the required parameter.
✓ The parameters to be set are displayed in the following sequence:
– Brightness: 0 – 100
– Contrast: 0 – 100
– Saturation: 0 – 100
– Volume: 0 – 100
– Language: English, French, German
– Mirror AV1/AV2/AV3/AV4: Yes or No
– Video AV1/AV2/AV3/AV4: Yes or No
– Distance grid: ON or OFF
– Trailer detection: ON or OFF
– Day/night mode: ON or OFF
– Default: Default setting for all parameters
➤ Press the "+" button (3) or the "–" button (4) to set the required parameter.
➤ Press the "+" button (3) to increase the value of the selected parameter.
➤ Press the "–" button (4) to reduce the value of the selected parameter.
EN
button (fig. 0 2, page 6) to switch the monitor on.
Using the LCD monitor
17