Dometic PERFECTVIEW M71L Instructions De Montage page 16

Installing the LCD monitor
Cover the holes with the feed through (fig. b 1, page 7) in the base of the monitor bracket.
•
•
To prevent damage to the cables, when laying them ensure that there is always a sufficient dis-
tance to vehicle components which can become hot (lights, heaters, ventilators etc.).
When laying the cables (fig. 3, page 4), make sure:
•
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp-edged through-holes without protection
Connecting the monitor as a reversing video system (fig. d, page 8)
➤ Lay the connection cable for the monitor bracket on the dashboard.
➤ Insert the plug of the monitor cable (2) into the socket (4) of the connection cable (3).
Wait until you hear the plug snap in.
A
NOTICE! Risk of damage!
Make sure the polarity is correct when connecting to a voltage source.
➤ Connect the red and black cables of the connection cable to a suitable voltage supply:
– Connect the red cable (5) to terminal 15 (ignition).
– Connect the black cable (6) to terminal 31 (earth).
➤ If the monitor is to be activated when reverse gear is selected, connect the green cable (7) to
the positive cable of the reversing light.
I
NOTE
If voltage is present at the green cable (7), the reversing camera is activated. The
reversing camera has priority.
➤ If the monitor is to be activated e.g. when the indicator is flashing, connect the following con-
trol cable to a positive cable of the indicator:
– white cable (8), blue cable (13)
I
NOTE
If voltage is present in this control cable, the video inputs AV2 and AV3 will be acti-
vated.
This control cable is used as a signal cable for the activation of a side camera when an indicator is
flashing, for example.
➤ If necessary, connect the AV1 socket (9) of the connection cable to the plug of video source 1
(e.g. reversing camera).
➤ If necessary, connect the AV2 socket (10) of the connection cable to the plug of the video
source 2 (e.g. side camera).
➤ If necessary, connect the AV3 socket (11) of the connection cable to the plug of video source 3
(e.g. camera).
16
PerfectView M71L
EN