Using The Lcd-Monitor - Dometic WAECO PerfectView M7LS Instructions De Montage Et De Service

_M7LS.book Seite 35 Freitag, 14. Oktober 2011 5:32 17
PerfectView M7LS
➤ Connect the red and black cables of the connection cables to a suitable
voltage source:
– Connect the red cable (5) to terminal 15 (ignition).
– Connect the black cable (6) to terminal 31 (earth).
➤ If necessary, connect the mini DIN socket (7) of the connection cable to the
mini DIN plug (9) of the system cable (10).
➤ Connect the mini DIN socket (11) of the system cable (10) of to the mini DIN plug (12)
of the camera cable.
➤ Connect the green cable (8) to the positive cable of the reversing light.
NOTE
I
If a voltage is present on the green cable, the monitor is switched on automati-
cally and the camera is activated.
8

Using the LCD-monitor

8.1 Switching on the monitor (fig. d, page 8)
NOTE
I
The monitor is switched on automatically, if you shift into reverse gear. The
image is transmitted by the camera.
➤ If the monitor is switched off, press the "Power" main switch (6), to switch the monitor
on.
✓ The picture appears.
✓ The brightness of the display is automatically adapted to the ambient light.
8.2 Switching off the monitor (fig. d, page 8)
➤ Press the main switch "Power" (6), to switch off the monitor.
✓ The picture disappears.
8.3 Setting the volume (fig. d, page 8)
You can set the volume to amplify or mute the the noises transmitted by the camera.
➤ Press the "–" button (3) to reduce the volume.
➤ Press the "+" button (5) to increase the volume.
EN
Using the LCD-monitor
35