Unpacking; Product Specifications - Optika Italy B-380 Serie Manuel D'utilisation

Unpacking

The microscope is housed in a moulded Styrofoam container. Remove the tape from the edge of the container
and lift the top half of the container. Take some care to avoid that the optical items (objectives and eyepieces)
fall out and get damaged. Using both hands (one around the arm and one around the base), lift the microscope
from the container and put it on a stable desk.
Place the metallographic attachment onto the top of the stand and tighten the lock-screw. Then place the obser-
vation head onto the top of the attachment and tighten the other lock-screw. Insert the eyepieces into the eye
tubes and fix them with the tiny screws on the side of the eye tubes. Remove the plastic protection film from the
microscope stage.
Connect the cable from the epillumination LED to the upper jack on the rear, and the provided +6Vdc power sup-
ply to the lower jack (marked with "6V" label).

Product specifications

Head:
Eyepieces:
Nosepiece:
Objectives:
Focusing system:
Stage:
Condenser:
Illumination:
Power supply:
Metallurgical
Attachment:
Filters:
Trinocular, 30° inclined, 360° rotating. Interpupillary adjustment 48-75 mm.
WF10X/20mm.
5-position reversed revolving nosepiece. Ball bearing rotation.
PLAN IOS MET 4x/0.10, 10x/0.25, 20x/0.40, 50x/0.75.
Coaxial coarse and fine.
Double layer mechanical sliding stage, dimensions 216x150mm, moving range 78x54mm.
Belt-drive in X direction. Glass insert for sample support.
Abbe condenser, sliding-in, N.A. 1.25 with centering system.
Transmitted light: X-LED
External power supply: Input 100-240Vac 50-60Hz / Output 6Vdc 1A.
High-power white X-LED
Blue, polarizer & analyzer.
, with manual brightness control.
3
; field and aperture diaphragms.
3
Page 4