Setting The Audio Options - Pioneer HTP-SB300 Mode D'emploi

Listening to your system

Setting the Audio options

There are a number of additional sound
settings you can make using the AUDIO
PARAMETER menu. The defaults, if not stated,
are listed in bold.
Important
• Note that if a setting doesn't appear in the
AUDIO PARAMETER menu, it is
unavailable due to the current source,
settings and status of the system.
SYSTEM
SYSTEM
INPUT SOURCE
INPUT TV CONTROL
HDMI1 HDMI2
OPTICAL COAXIAL INPUT
Setting
S.DELAY
(Sound Delay)
MIDNIGHT
LOUDNESS
S.RTV
(Sound Retriever)
Downloaded From TheatreSystem-Manual.com Manuals
All manuals and user guides at all-guides.com
ENTER
CH
What it does
Some monitors have a slight delay when showing
video, so the soundtrack will be slightly out of sync
with the picture. By adding a bit of delay, you can
adjust the sound to match the presentation of the
video.
Allows you to hear effective surround sound of movies
at low volumes.
Used to get good bass and treble from music sources
at low volumes.
When audio data is removed during the WMA/MP3
compression process, sound quality often suffers from
an uneven sound image. The Sound Retriever feature
employs new DSP technology that helps bring CD
quality sound back to compressed 2-channel audio by
restoring sound pressure and smoothing jagged
artifacts left over after compression.
1 Press on the remote control,
then press AUDIO PARAMETER button.
Use / to select the setting you want to
2
adjust.
Depending on the current status/mode of the
system, certain options may not be able to be
selected. Check the table below for notes on
this.
Use / to set it as necessary.
3
See the table below for the options available for
each setting.
4 Press RETURN to confirm and exit the
menu.
Option(s)
0.0 to 9.0 (frames)
1 second = 25 frames
(PAL)
Default: 0.0
M/L OFF
MIDNIGHT
LOUDNESS
OFF
ON
04
23
En