3M PELTOR ComTac V Guide D'utilisation page 10

3. Factory Reset
Resets all menu settings to the factory default values. To reset, navigate to the Factory Reset
menu, press the [+] when the ghost voice states, "confirm factory reset".
4. Release Time - Advanced Setting
The release time setting adjust the time before the limiter for the level-dependent function opens
after activation. To adjust to either fast or slow levels, navigate to the Release Time menu,
press [+]/[-] button for fast/slow levels.
5. Balance - Advanced Setting
The balance setting adjusts the volume and balance between the right and left ear. To adjust
to one of the seven levels (center, right/1, right/2, max right, max left, left/2, or left/1), navigate
to the balance menu. Press [+]/[-] button accordingly.
6. Active Volume Troubleshooting
If the audio is weak or the system fails to activate ensure that the volume control is properly
adjusted and the batteries have not lost power.
Headband / ARC Helmet Attachment Conversion Instructions
1. Unclip the rubber headband clips (F:1 and F:2). Pull the clip out until open. Repeat for
opposite clip.
2. Unfold the rubber band by pulling out the ridge attachments one by one (F:3 and F:4).
4. Rotate the right cup 90º degrees (the one without the boom microphone) to detach the earcup
arm guide as shown in F:7, 8 and 9. Mild force is required.
look like F:10.
6. Detach the boom microphone connector from the connector jack on the left cup as shown
in F:11 and 12.
Mild force is required.
should look like F:16.
9. Rotate the boom microphone earcup arm guide 90º degrees to make sure it detaches with
relative ease and remove the boom microphone earcup arm guide as shown in F:17 and F:18.
NOTE: Make sure you rotate the boom microphone earcup arm guide as shown in the figures,
because of the earcup arm guide lock when it is positioned in place.
10. Remove the existing boom microphone earcup arm guide on the helmet attachment by
rotating it 90º degrees to make sure it detaches with relative ease, and remove the boom
microphone earcup arm guide from the helmet attachment as shown in F:19 and F:20.
NOTE: There is only one boom microphone earcup arm guide on the helmet attachment.
Rendered on 1/23/2020 10:54:14 AM
10
Page 10 34-8725-1903-7 ComTac V manual.pdf