Focal PERFORMANCE DIRECT FET Manuel D'utilisation page 14

All manuals and user guides at all-guides.com
FOCAL DIRECT FET PERFORMANCE
®
U s e r m a n u a l
14
3.6 – Wiring power supply to your FD amplifier
CAUTION
The cable connecting the positive (+) terminal of the battery to the "+ BATT" terminal of the amplifier MUST be fused
(ampere rating: 30 amperes) less than 40cm away from the battery of the vehicle.
The connections on the fuse holder must be fully insulated.
Open the fuse holder, removing the fuse with care. Fix the base of the fuse holder.
Cut a length of power cable between 10 and 40cm (maximum). Strip 1cm, then tin. Screw the cable to the terminal of
the fuse holder (battery side). Crimp the power cable to the intended spade terminal and screw to battery terminal.
Strip 1cm from the remaining length of cable, then tin. Screw the cable to the other fuse holder terminal.
40cm max
fig. 5
Prepare the positive power cable (+) to connect it to the amplifier by using the adequate Y-type spade terminal, then
block the cable by screwing tight. (fig. 5)