Bras FBM L Carnet D'instructions page 14

EN GLIS H
F B M L
fastening hooks (see figure 6) and slide it out (see figure 7).
3
Slide the outer spiral out (see 3) and then the inside auger
(see figure 9).
figure 6
figure 7
figure 8
figure 9
4
Remove the bowl gasket from its seat (see figure 10).
5
Dismantle the faucet assembly (see figure 11).
6
Slide the drip tray out and empty it.
5. 3. 2 CLEANING
IMPORTANT
Do not attempt to wash any machine components in a
dishwasher.
ATTENTION
Before any disassembly and/or cleaning procedure make
sure that the dispenser is disconnected from its power
source.
1
Prepare at least two gallons of a mild cleaning solution of
warm (45-60 °C 120-140 °F) potable water and dishwashing
detergent. Do not use abrasive detergent.
Important: if present, follow label directions, as too strong a
solution can cause parts damage, while too mild a solution will
not provide adequate cleaning.
IMPORTANT
In order to prevent any damages to the dispenser use
only a detergent suitable with plastics parts.
2
Using a brush, suitable for the purpose, thoroughly clean all
14
figure 10
figure 11