Festo HMPL KP Série Notice D'utilisation page 17

HMPL−...−KP
5. Fasten the linear module with the clamp
ing unit using one of the following
methods:
Fitting to linear module HMPL−... using
the screws provided (M5 x 45)
Fitting to linear module type
HMP−16/20−... using the screws pro
vided (M5 x 52)
Fitting to linear module type
HMP−25/32−... using M5 x 55 screws
(not included)
Fitting to the fastening plate.
The maximum screw−in depth L of the
clamping unit and linear module required
for mounting on a fastening plate is 38 mm.
S Fasten with at least two screws in the
holes 3.
Fitting pneumatic components
Connect the tubing to the screw con
S
nectors (PK−4) on the clamping unit.
Pneumatic control of the HMPL−...−KP:
Use a common source of compressed air
S
for connecting the valves (e.g. connection
as in Fig. 11 with CP.. valve terminal).
In this way, the clamping rod will be
clamped in the event of a drop in pres
sure.
Festo HMPL−...−KP 0501a English
HMPL−...
Fig. 7
Fig. 8
Ó Ó Ó
Ó Ó Ó
Ó Ó Ó
Fig. 9
Fig. 10
Ó Ó Ó
Fig. 11
HMP−...
L
17