Technical Data; Assembly - Hilti ST1800 Mode D'emploi

Fiber-cement board
on steel beam S-FD 05 / 6.3 (14)
Fiber-cement
board on wood S-FD 01 / 6.5 (14)
Sandwich panel
on steel profile S-CD 63 / 5.5 (12)
Sandwich panel
on steel beam S-CD 65 / 5.5 (12)
Sandwich panel
on wood S-CDW 61 / 6.5 (14)
The above settings are intended as an approximate guide-
line. They result from evaluation of the characteristic
curves for the torque clutches of tools tested in quality
assurance tests and from torque values obtained from
the corresponding screw tests.

Technical data

Tool
Rated power
Rated voltage
Rated current
Mains frequency
Weight of tool
Dimensions (L×W×H)
Chuck
Speed under no load
Max. torque
Speed control
Torque adjustment
Forward / reverse
Double insulation
Mechanical clutch
Vibration-absorbing grip
Right of technical changes reserved!

5. Assembly

-NOTE-
The electric supply voltage must comply with
the information given on the rating plate.
5.1 Fitting the scaffold hook
1. Unplug the supply cord from the electric socket.
2. Slide the scaffold hook over the tool from the front.
3. Rotate the scaffold hook into the desired position.
4. Secure the scaffold hook by tightening the knurled
screw.
-CAUTION-
Check that the scaffold hook is attached securely to the
tool.
Printed: 07.07.2013 | Doc-Nr: PUB / 5070704 / 000 / 00
All manuals and user guides at all-guides.com
Chuck:
12–15
Operating controls
Control switch with lockbutton
12 – max.
Forward / reverse pushbutton
Torque adjusting ring
2–7
Depth gauge adjusting ring
2–9
Items supplied as standard equipment
– ST 1800 electric screwdriver
5–8
– S-GT17 depth gauge (for screws with sealing
washers of up to 17 mm / 0.67 in diameter)
– Operating instructions
– Toolbox or cardboard box (depending on version)
ST1800
600 W (WH version (120 V) 670 W)
120 V
6.1 A at 120 V
50 / 60 Hz
1.8 kg (4 lb)
308×72×265 mm (12×2.8×10.4 in)
" hexagon socket
1 /
4
0–1900 r.p.m.
22 Nm (195 in - lb)
Electronic, by way of control switch
In 18 increments / 1.5–22 Nm (18 to 195 in - lb)
Pushbutton
Protection class II Z
5.2 Removing the protective sleeve
1. Unplug the supply cord from the electric socket.
2. Insert the tip of a screwdriver in the gap between the
3. Pull the protective sleeve off toward the front end of
5.3 Use of a generator or transformer
This tool can be powered by a generator or by way of a
transformer connected to the construction site electric
supply when the following conditions and specifications
are fulfilled:
– Alternating current, power output at least 2600 W.
" hexagon socket
1 /
4
tool and the protective sleeve. Pry the protective sleeve
away from the tool by turning the screwdriver.
the tool.
en
5