IKEA KONSISTENS Mode D'emploi page 8

NOTE TO ELECTRICIAN: The armored cable leads
supplied with the appliance are UL-recognized for
connection to larger gauge household wiring. The
insulation of the leads is rated at temperatures
much higher than temperature rating of household
wiring. The current carrying capacity of the
conductor is governed by the temperature rating
of the insulation around the wire, rather than the
wire gauge alone.
Where local codes permit connecting the
appliance-grounding conductor to the neutral
(white) wire (US Only) (see figure 3):
1. Disconnect the power supply.
2. In the junction box:
connect appliance and power supply cable wires
as shown in Figure 3.
Cable from Power Supply
White Wire
(Neutral)
Red
Wires
Ground Wire
(Bare or Green
Wire)
Cable from appliance
3-WIRE GROUNDED JUNCTION BOX
8
Black
Wires
Junction
Box
White Wire
(Neutral)
U.L.-Listed Conduit
Connector (or CSA
Figure 3
If oven is used in a new branch circuit installation
(1996 NEC), mobile home, recreational vehicle,
or where local codes DO NOT permit grounding
through the neutral (white) wire, the appliance
frame MUST NOT be connected to the neutral wire
of the 4-wire electrical system. (see figure 4):
1. Disconnect the power supply.
2. Separate the green (or bare copper) and white
appliance cable wires.
3. In the junction box:
connect appliance and power supply cable wires
as shown in Figure 4.
Ground Wire
Red
Wires
Ground Wire
(Bare or Green
Wire)
Junction Box
4-WIRE GROUNDED JUNCTION BOX
Model and Number Location
The rating plate is located along the interior side
trim of the oven and visible when the door is
listed)
opened.
When ordering parts for or making inquires about
your oven, always be sure to include the model
and serial numbers and a lot number or letter
from the rating plate on your oven.
Cable from Power Supply
U.L.-Listed Conduit
Connector (or CSA
Cable from appliance
Figure 4
Single Wall Oven
Rating Plate Location
White Wire
Black
Wires
White Wire
listed)
AA-2194875-2