Cornelius CANYON Instructions D'assemblage page 22

12
Same procedure for the straight section with the top plate but you
have to screw the cap extention into the buttress post with two (2)
screws ''Z'' on each side.
13
14
Snap the seat cap starting outside the top seat.
Then snap the other side inside the top seat.
Snap the plastic cap in the middle of the top seat if no light is used.
PLASTIC
CAP
BUTTRESS POST TOP PLATE
TOP SEAT INSTALLATION
SEAT CAP INSTALLATION
(straight section)
CAP EXTENSION
STRAIGHT SECTION
Place the top seats on the top of the uprights ensuring that the rod
under the seat is inserted into the oblong holes in the top plate.
Be sure to have a vertical (plumb) upright
before fixing the top seat.
Evenly distribute the top seats all around
the pool.
Secure the top seat in place using four
(4) "Z" screws where indicated.
FIXE THE FRONT
HOOK FIRST
TOP PLATE
SCREW ''Z''
BUTTRESS POST
SEAT CAP
UPRIGHT