Wall Installation - Cornelius CANYON Instructions D'assemblage

5
1) Dump the sand.
2) Choose the filter location beside a round section (never a straight
section). The starting point will be at that location so that the skim-
mer and return holes are as close as possible to the filtration sys-
tem.
3) Before uncoiling the wall, make sure the pre-punched holes for
the skimmer and pump return are at the top and facing the planned
location of your filter.
SAND
Begin inserting the wall into the bottom wall tracks in the middle of
a joiner plate. At first, the wall is kept in place with one or two sup-
port bars (or extra persons). One person uncoils the wall on a beam
or a plank, while a second person inserts it in the bottom wall
tracks. Do not uncoil more than 3 m (10') of wall before you install
a support bar to reinforce the structure.
Once the wall is completely uncoiled, you may find that it is too
long or that both ends do not meet by a few centimetres. If such is
the case, you must gently push the wall in or out. If this does not
work, roll up the wall again, realign the grooves and uncoil the wall
again. If the spread is too wide, measure the wall and check it
against the following chart.
Illustration 8.1
BOLT
MODEL
Chart
ACTUAL LENGHT
OF THE WALL

WALL INSTALLATION

PLANKS PLANKS
SUPPORT
BAR
Inside pool
End
Outside pool
NUT
10x16 10x21 13x18
42' 4-3/4" 53' 3-3/4" 48' 11"
(12,92m) (16,25m) (19,91m)
WALL
JOINER PLATE
When you prepare to join the ends of the wall, make sure the end
that is reinforced by the fold is inside the circle, facing the liner and
that the other end faces outward (Illustration 8.1).
When the wall joint is secured, install the round stabilisers on top
of it.
IMPORTANT: Do not use impact gun!
Minimum clamping force of 60inch pounds to maximum of
85 inch pounds.
13x23 15x20 15x26
59' 8" 56' 6" 67' 5"
(18,24m) (17,22m) (20,55m) (23,90m)
End
SKIMMER HOLE
PUMP RETURN
HOLE
BOTTOM TRACK
15x31 18x33 18x38
78' 5" 86' 96' 11"
(26,21m) (29,54m)
18x44
107' 11-1/2"
(32,91m)