Cornelius CANYON Instructions D'assemblage page 21

10
Installation detail of the liner with the square resin track.
Hang the liner on the top of the wall and install the square stabiliser
to secure.
Start the vacuum cleaner to allow the liner to adhere to the wall and
check for excess tension at the bottom or for wrinkles. Adjust the
liner by removing couplers if needed, to lift or lower it in order to
ensure a perfect fit.
11
For the round section:
Attach the uprights to the bottom joiner plates with two (2) screws
''Z'', which can be found in the hardware bag.
Uprights must be installed inside the joiner plate.
12
Install the top plate into the upright and secure with two (2) screws
''Z'' on each side.
Clip the cap extension into the upright.
Make sure it snaps into the upright in the round section.
VINYL LINER INSTALLATION (continued)
WALL
TRACK
LINER
WALL
BUTTRESS POST INSTALLATION
BUTTRESS POST TOP PLATE
Fill the pool up to the base of the wall before stopping and removing
the vacuum cleaner.
PUMP RETURN FITTING
After you remove the vacuum cleaner, you may install the return fit-
ting. Place the return fitting ring against the liner and adjust it so
that it is perfectly aligned with the hole in the wall. When the ring is
properly positioned and secured, cut the liner in the middle of the
ring.
Insert the return fitting from the inside, placing the first gasket be-
tween the return fitting and the liner and the second between the
wall and the liner. Then tighten the outside ring with large pliers, tak-
ing care not to crease the liner.
BOTTOM DRAIN (optional)
Find the holes through the middle of the liner and screw the ring
and gasket in against the liner before cutting the liner in the middle
of the ring, then screw on the drain cover.
JOINER PLATE
(round section)
CAP EXTENSION
UPRIGHT
SCREW ''Z''
BOTTOM TRACK
TOP PLATE
SCREW ''Z''
UPRIGHT