Hood Surface Cleaning; Heat Lamps (Phxxgws Only) - Thermador Professional Serie Guide D'utilisation Et D'entretien

Hood surface cleaning

• For general care, wipe the outside of the stainless
steel with mild, lukewarm, soapy water. Always wipe
and dry in the direction of the stainless steel grain.
Avoid using too much pressure, which may mar the
surface.
• DO NOT use abrasive products such as steel wool.
• DO NOT use cellulose sponges. Some sponges are
processed with salt and can cause corrosion by leaving
salt deposits on the metal.
• DO NOT allow any cleaning compounds to remain in
contact with stainless steel for extended periods.
• DO NOT USE CHLORINE-BASED CLEANERS.
• To remove fingerprints and produce added shine, use
a stainless steel cleaner or conditioner. The
Thermador Stainless Steel Conditioner can be
purchased online (US only) at:
www.store.thermador.com (order part number
00576697).

Heat lamps (PHxxGWS only)

9 WARNING
Heat lamps might be hot. Disconnect from power and
allow to cool before servicing.
DO NOT operate the appliance without the heat lamps
installed.
Turn off the heat lamps and blower. Allow the heat lamps
to cool before handling.
If new heat lamps do not operate, be sure lamps are
inserted correctly before calling for service.
15
Heat lamp installation
1. Turn heat lamp clockwise to install.
Heat lamp replacement
1. Turn heat lamp counterclockwise to remove.
2. Replace lamp with either a PAR-38 175W heat lamp or
a PAR-40 250W heat lamp.
The PAR-38 175W heat lamp provides a tighter seal within
the enclosure and produces the same amount of effective
heat with lower energy consumption. These lamps may
not be readily available at local retail outlets. The PAR-40
250W heat lamp is more widely available. It can be used
instead.
PAR-38 175W heat lamps can be purchased through the
following retailers:
• OpTech Inc: 800-848-6624 or
www.optechlightbulbs.com
• bulbs.com: 888-455-2800 or www.bulbs.com