Care And Cleaning; To Clean Hood Surface - Thermador PROFESSIONAL PH Serie Guide D'utilisation Et D'entretien

Care and Cleaning

Cleaning

To Clean Hood Surface

WARNING:
Be sure the entire appliance (including the filters and
light bulbs) has cooled and grease has solidified before
attempting to clean any part of the appliance.
• For general care, wipe the outside of the stainless steel
with sudsy water or household cleaners such as
®
Fantastik or Formula 409
clean soft cloth to avoid water marks.
• Wipe and dry stainless steel in the same direction as
the grain. Avoid using too much pressure, which may
mar the surface.
• Do not use abrasive products such as steel wool.
• To remove finger prints and give added shine, use a
stainless steel cleaner such as Stainless Steel Magic
Hadco Stainless Steel Polish, Sprayway
Steel Polish and Cleaner, or 3M Stainless Steel
Cleaner and Polish.
• Do not allow any cleaning compounds to remain in
contact with stainless steel for extended periods.
NOTICE:
The use of brand names is intended only to indicate a type
of cleaner. This does not constitute an endorsement. The
omission of any brand name cleaner does not imply its
adequacy or inadequacy. Many products are regional in
distribution and can be found in the local markets. It is
imperative that all products be used in strict accordance
with instructions on the package.
Filter, Filter Spacers, and Grease Tray
Cleaning
Your hood has removable aluminum or stainless steel
filters, stainless steel grease trays and stainless steel filter
spacers. They must be cleaned when the filter light
illuminates on the control panel or whenever they collect
grease. When used over a grill, wok or other high grease
applications, more frequent cleaning may be required.
English 6
®
, rinse well and dry with a
®
Stainless
NOTE:
Do not use cooktop, rangetop, or range while hood is
disassembled.
To Remove Filters and Grease Trays:
1. Turn the fan and lights off. Be sure filters are cool and
grease has congealed before removal.
2. Remove in the following order:
1) Filters — Depending upon the size and model of
hood, there will be 2 to 4 filters per hood. Start with
center filters, push up, then pull out from the
bottom.
2) Filter Spacers — Remove these the same way as
the filters.
3) Grease Trays — lift up and out.
3. Reverse the above directions to reinsert the grease
trays, filter spacers and filters.
The rating label and serial number labels are on the hood
filter spacers and are visible after the filters have been
removed.
®
,
The filters and grease trays can be washed by hand or in
the dishwasher. The front and side panels may be washed
with warm soapy water and polished with stainless steel
cleaner.
Filter
Spacer
Grease
Tray
2
2
1
1
Filters
Figure 3: The hood and parts
Filter
Spacer