Operation; Energy Saving Tips; Using The Minibar - Dometic DESIGN DM20D Notice D'utilisation

Operation

➤ Push the plugs (3) on the screws of the door handle (4).
➤ Push the drawer into the cabinet.
7 Operation
A
NOTICE! Damage hazard
The lamp can only be replaced by the manufacturer, service agent or
similarly qualified person to avoid hazard.
7.1

Energy saving tips

• Do not open the cooling device more often than necessary.
• Do not leave the cooler unit open for longer than necessary.
7.2

Using the minibar

The minibar starts cooling when connected to power. During normal operation the
Status LED is glowing. If an error occurs the Error LED is blinking (see chapter "Trou-
bleshooting" on page 19).
The minibar is set by default to a cooling temperature of 7 °C at an ambient
temperature of 25 °C.
You can use the setting button (fig. 3 4, page 4) to set the cooling temperature to
one of three values (5 °C, 12 °C and 7 °C).
Thereby the temperature will be changed in the order 5 °C ... 12 °C ... 7 °C ... 5 °C
etc.
➤ Press the setting button (fig. 3 4, page 4) and keep it pressed for 5 s, until the
lamp (fig. 3 1, page 4) starts to blink.
➤ Press immediately the setting button (fig. 3 4, page 4) again.
✓ The lamp (fig. 3 1, page 4) indicates the setting temperature:
– 5 °C: the lamp flashes five times in three intervals
– 12 °C: the lamp flashes once in three intervals
– 7 °C: the lamp flashes three times in three intervals
I
NOTE
The minibar sets the cooling temperature automatically to 7 °C, when it
is connected to a power source.
18
DM20
EN