LG WL Serie Manuel D'utilisation page 19

6
The cabinet should be installed with a very slight tilt
(about 1/2") downward toward the outside
(See Fig. 5).
Adjust the bolt and the nut of Sill Support
balancing the cabinet.
7
Attach the cabinet to the window stool by driving
the screws (Type B: Length 16mm (5/8 inch)
and below.) through the front angle into window
stool.
8
Pull each Frame Curtain
sash track, and repeat step 2.
9
Attach each Frame Curtain
screws (Type C). (See Fig. 6)
CAUTION: Do not drill a hole in the bottom
pan. The unit is designed to operate with
approximately 1/2" of water in bottom pan.
There is no need to add water if the pan is
dry.
10
Slide the unit into the cabinet. (See Fig. 7)
CAUTION: For security purpose, reinstall
screws (Type A) at cabinet's sides.
11
Cut the Foam-Strip
between the upper window sash and the lower
window sash. (See Fig. 8)
for
fully to each window
the window sash using
to the proper length and insert
Screw(Type B)
6
Screw(Type B)
Sill Support
2
Screw(Type A)
Power cord
Hardware Installation
Sill Support
2
Sash track
Front Angle
6
Fig. 5
Type C
7
Fig. 6
Screw
Fig. 7
(Type A)
Foam-Strip
8
Fig. 8
Owner's Manual 19