Cooling Unit - GYS NEOPULSE 400 Mode D'emploi

SPECIFICATIONS FOR THE INTERCONNECTION CABLE (WIRE FEEDER INTO POWER SOURCE)

COOLING UNIT

This machine may be connected to a NEOCOOL cooling system for the cooling of the water torch. The recommended cooling system unit is auto-
matically detected by the TIG 300 DC. To deactivate the cooling unit, check the wire feeder's manual. For installation, refer to the cooling unit's
instruction manual.
Make sure that the cooling unit is switched off before disconnecting the inlet and outlet hoses for torch liquid.
The coolant is harmful and irritates the eyes, the mucus membranes and the skin. Hot liquid may cause burns.
CONNECTION THE INTERCONNECTION CABLE
Before connecting the interconnection cable, cut the power supply using the interrupor behind the machine .
Do not connect the electrode holder when using the machine in MIG / MAG mode.
• MIG / MAG WELDING
BACK OF THE DEVICE
• MIG / MAG WELDING (POLARITY REVERSAL)
Be cary of the welding current polarity ! Certain types of wire must be welded with a negative polarity. In this event, a polarity
reversal cable must be used (optional, ref. 033689).
NEOPULSE 400
A
1
C
2
B
Y 3
D
4
Z
A E
5
F
6
B
G
+24V 7
H
8
M24V
J
9
M48V
K
+48V 10
53056
A
B C
D E F G
H J
K
FRONT OF THE DEVICE
EN
DESCRIPTION
1 Control
2 Gas
3 Power
4
Cooling
5
17