Starting Attempt - Stanley SXAE00135 Instructions D'utilisation

3.2. Starting attempt

When using the booster to start an engine, do not crank for more than 3 seconds, and wait
at least 1 minute before a second attempt.
If the car does not crank a second time, check the smart cable to see if the green LED is lit (solid). If
you hear beeping or an LED is flashing, refer to Troubleshooting.
If no activity is detected, the smart cable will automatically shut off after 120 seconds, and the red and
green LEDs will be solid. Disconnect the booster from the vehicle battery, then restart from Jump
Start Step 1.
NOTE: Cold weather may affect the performance of the booster's lithium battery. If you hear only a
click and the engine does not turn over, try the following:
With the booster connected to the car battery and the green LED solid on the smart cable, turn on all
lights and electrical accessories for one minute. This draws current from the booster and warms the
battery. Now try to crank the engine. If it does not turn over, repeat the procedure. Extremely cold
weather may require two or three battery warmings before the engine will start.
IMPORTANT: DO NOT attempt to jump start your vehicle more than three consecutive times. If the
vehicle will not start after three attempts, consult a service technician.
3.3. To charge a mobile device, using the USB ports
The booster includes two USB ports. One provides up to 2,4A at 5V DC; the other is a Quick Charge
3.0, which provides up to 5V at 3A, 9V at 2A or 12V at 1,5A.
1. Consult your mobile device manufacturer for proper charging power specifications. Connect
a mobile device cable to the appropriate USB port.
2. Slide the ON/OFF switch to the ON position. Charging should begin automatically. The
display will show which port is in use.
3. Charging time will vary, based on the mobile device's battery size and the charging port
used. NOTE: Most devices will charge with either USB port, but may charge at a slower rate.
4. When finished using the USB port, disconnect the charging cable from your mobile device
and then disconnect the charging cable from the unit. Slide the ON/OFF switch to the OFF
position.
5. Recharge the unit as soon as possible after each use.
NOTE: If no USB device is connected, power to the USB ports will automatically shut off after 30
seconds.
3.4. Maintenance
After unplug and disconnect the unit, use a dry cloth to wipe all battery corrosion and other dirt or oil
from the battery clamps, cords, and the outer case.
3.5. Storage
 Charge battery to full capacity before storage. Charge at least once every month, if not in frequent
use, to prevent over-discharge.
 Store this unit at temperatures between -10°C - +40°C.
4. Troubleshooting
4.1. Booster
PROBLEM
The booster's display will not turn on.
The thermometer symbol is flashing.
The booster will not recharge.
SOLUTION
Make sure the unit is charged.
Connect to a power source, to reset.
Make sure the ON/OFF switch is set to the ON position.
The unit is too hot or cold. The thermometer symbol will
disappear when the condition is removed.
Make sure the power source is live.
6