General Information; Technical Specifications - Stanley SXAE00135 Instructions D'utilisation

1. Before plugging the clamps into the unit, attach the output cables to the battery and chassis as
indicated below. Never allow the output clamps to touch each other.
2. Position the DC cables to reduce the risk of damage by the hood, door and moving or hot engine
parts. NOTE: If it is necessary to close the hood during the jump starting process, ensure that the
hood does not touch the metal part of the battery clamps or cut the insulation of the cables.
3. Stay clear of fan blades, belts, pulleys and other parts that can cause injury.
4. Determine the voltage of the battery by referring to the vehicle owner's manual and make sure
that the output voltage of the booster is correct.
2.

General information

2.1. Description
1. LCD Display
2. Power button
3. USB port - 5V-2,4A
4. USB port Qualcomm® Quick Charge™ 3.0
Technology
5. Micro/USB input socket for recharging
6. ON/OFF Switch
7. Battery clamps with Smart cable
8. Output socket for Smart cable
9. LED light
Not shown:
Micro/USB cable & Zipper carry case
Qualcomm Quick Charge is a product of Qualcomm Technologies, Inc. and/or its subsidiaries. Qualcomm and Quick Charge
are trademarks or registered trademarks of Qualcomm Incorporated.

2.2. Technical specifications

Reference
Model
Capacity
Output Voltage
Start Amps
Peak Amps
Internal Battery type
USB output
2.3. Charging the booster
2.3.1. Checking the level of the internal battery
Slide the ON/OFF switch to the ON position. The LCD display will show the battery's percentage of
charge. A fully charged internal battery will read 100%. Charge the internal battery if the display shows
it is under 85%.
2.3.2. Charging the internal battery
Charge the unit as soon as possible after use. Never completely discharge the battery.
Use a 2A USB charger (not included), or a 2A USB charging port to quickly recharge the booster.
Using a charger with less than 2A will increase charge time.
1. Plug the Micro USB end of the charging cable into the input port. Next, plug the USB end
of the charging cable into a charger's USB port.
2. Plug your charger into a live AC or DC power outlet.
3. The LCD display will light; the digit begins to flash and show "IN", indicating that charging
has begun.
4. The booster will be fully charged in about 6 hours (with 5V DC, 2A charging input). When
the unit is fully charged, the display will show "100%".
SXAE00135
Lithium booster 12V-1000A
11.200mAh / 41,44Wh
14,8V (For 12V vehicle)
500A
1000A
Lithium ion (Pouch cell)
5V DC - 2,4A / QC 3.0
4