Location Of Controls; Front View - Panasonic KX-UT248 Guide Rapide

Location of Controls

Location of Controls

Front View

G
A LCD (Liquid Crystal Display)
KX-UT248 is equipped with a 4.4-inch LCD and LCD backlight.
B Soft Buttons (S1 to S4)
S1 to S4 (located below the display) are used to select the item displayed on
the bottom line of the display.
C FORWARD/DO NOT DISTURB
Used to set Call Forwarding or Do Not Disturb on your extension.
D CONF (Conference)
Used to establish a local three-way conference.
E Message/Ringer Lamp*
When you receive a call or Hold Recall, the lamp flashes green.
When someone has left you a message, the lamp stays on red.
*1 If the unit is connected to a KX-NS1000 PBX, the Message/Ringer Lamp
shows the current status as follows:
– Green flashing: You are receiving an intercom call, or you are
receiving a Hold Recall or Transfer Recall from an extension.
– Red flashing: You are receiving an outside call, or you are receiving a
Hold Recall or Transfer Recall from an outside line.
– Red on: You have a message.
8
A B
H
I J
1
C
K L I H MNOPQ
D E F
RS