Safety Notes; General Notes; Functions; Spare Parts - Trix MINITRIX 52 Serie Mode D'emploi

Safety Notes

• This locomotive is to be used only with an operating
system designed for it.
• Use only switched mode power supply units and transfor-
mers that are designed for your local power system.
• This locomotive must never be supplied with power from
more than one power pack.
• Pay close attention to the safety notes in the instructions
for your operating system.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
• The wire used for feeder connections to the track may be
a maximum of 2 meters / 39 inches long.
• WARNING! Sharp edges and points required for operation.

General Notes

• The operating instructions and the packaging are a com-
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
• Please see your authorized Trix dealer for repairs or

spare parts.

• http://www.maerklin.com/en/imprint.html

Functions

• Trix locomotives can be operated on all 2-rail DC systems
with conventional DC power packs (12 volt DC).
• Maintenance-free, high-efficiency can motor with bell-
shaped armature.
• Dual headlights that change over with the direction of
travel.
• Close coupling between locomotive and tender.
• Locomotive comes with NEM 651
digital connector.
• NEM close coupler mechanism and coupler pocket at
tender.
• Analog 14 volts DC, digital 22 volts AC.
• Trix motor vehicles must not be operated on digital
systems without an built in engine decoder (Motor can be
damaged!).
• Based on the NEM 661 standard, the speed of the loco-
motive at 12 volts is set approximately at the maximum
speed for the prototype.
No warranty or damage claims shall be accepted in those cases where parts
neither manufactured nor approved by Trix have been installed in Trix products or
where Trix products have been converted in such a way that the non-Trix parts or
the conversion were causal to the defects and / or damage arising. The burden of
presenting evidence and the burden of proof thereof, that the installation of non-
Trix parts or the conversion in or of Trix products was not causal to the defects
and / or damage arising, is borne by the person and/or company responsible for
the installation and / or conversion, or by the customer.
NEM
7