Humminbird APEX Serie Guide D'installation page 6

APEX™ SERIES CONTROL HEAD Installation Guide
5. Select Settings > Network > System Info.
GPS: Confirm the GPS is listed as Enhanced Fix or 3D Fix. Confirm that a latitude/longitude
position is displayed in the Position digital readouts section.
Accessories: Review the list to confirm accessories are listed as connected. If an accessory is
not detected, check cable connections, confirm power is turned on, and review the installation
guide. The temp/speed accessory will be detected only if the paddlewheel has moved.
NOTE: You can access sensor port settings from Settings > Network. To turn on NMEA 0183
output, select NMEA 0183 sentences, set the baud rate, etc., select Settings > Network >
NMEA 0183.
6. Press the Home key.
7. Sonar Test: Test and finalize the transducer installation using the instructions in the transducer
installation guide.
8. When the transducer test and installation are completed, the APEX control head is ready for
on-the-water operation.
Use the Home screen to access settings, alarms, views, and tools. The options are determined
by the equipment attached to the control head network.
For operations information, see the Quick Start Guide included with your control head and the
APEX/SOLIX Operations Manual (available for download at humminbird.com).
6
532744-1_A