Maintenance Instruction - CLAS OH 0921 Mode D'emploi

OH 0951
DUAL-CONTROL PRESS 50T SLIDING CYLINDER

MAINTENANCE INSTRUCTION

CAUTION
• Do not use damaged/deformed product. If abnormal noise or vibration occurs, stop use immediately,
then inspect and ask manufacturer for help. It is recommended that this inspection be made by a
manufacturer's authorized repair facility.
• Keep the service jack clean and well lubricated to prevent foreign matter from entering the system.
If the jack has been exposed to rain, snow, sand, or grit, it must be cleaned before it is used.
• Store the jack, with pistons completely retracted, in a well-protected area where it will not be exposed
to corrosive vapors, abrasive dust, or any other harmful elements.
• Periodically check the condition of the product.
• Store the product in dry and non-corrosion environment.
• Lubricate the axes and moving parts at regular intervals.
• The elements of the press should be kept clean and protected from aggressive conditions at all times.
• Always use original spare parts.
• Owners and /or operators should be aware that repair of this equipment may require specialized
knowledge and facilities. It is recommended that an annual inspection of the product be made by a
manufacturer's or supplier's authorized repair facility and that any defective parts, decals, or safety
labels or signs be replaced with manufacturer's or supplier's specified parts.
• Any product that appears to be damaged in any way, is found to be worn, or operates abnormally
SHALL BE REMOVED FROM SERVICE UNTIL REPAIRED. It is recommended that necessary repairs
be made by a manufacturer's or supplier's authorized repair facility if repairs are permitted by the
manufacturer or supplier.
• Only attachments and/or adapters supplied by the manufacturer shall be use.