Safety Instructions - CLAS OH 0921 Mode D'emploi

OH 0951
DUAL-CONTROL PRESS 50T SLIDING CYLINDER

SAFETY INSTRUCTIONS

This press has been designed for general bending, toughening, axis and bearing extraction
work etc. Never use it for applications that should not be performed by a press. Always use the
appropriate tool for each specifi c task. Handle the press correctly and ensure that all parts and
components are in good condition and that no parts are missing prior to its use.
The press should only be used by authorized person should having read carefully and
understood the contents of this manual. All other persons, especially children, must be kept
out of the work area.
Always position the press against a wall. If the press is situated in the open workshop, it is
essential that a guard be placed at the rear of the unit. The press foot need to be amounted
on the ground!
Make sure that the operator must wear protective cloth, gloves, safety helmet, shoes and ear
protector during operating. To avoid accidents, always be aware of any on-going work on the
machine. Also, always stay focused on the job to be done.
Do not modify the press in any way. Safety valve should not be tampered with under any
circumstances.
Never exceed the rated capacity of the press and V-blocks.
Non-compliance with these instructions may result in injury or damage to the user, the press
or the piece being manipulated.
The manufacturer accepts no responsibility for the improper use of the press or the component
handled.