Deleting All Entered Data; Reset Operations - Perry Electric 7080 Serie Mode D'emploi

15 - DELETING ALL ENTERED DATA

In normal operation, if you wish to
for 3 seconds. After having performed the lamp-test cycle, the device will be ready for data entry.
Ok
Delete
Prog
3 sec.
1 2 3 4 5 6 7 1 2 3 4 5 6 7
16 - RESET OPERATION OR RESET WITH ACCUMULATOR DISCHARGED
Reset operations reset the time switch and are used for example upon initial start-up or if any anoma-
lies or malfunctions should be noted.
RESET
Lightly press with a sharp object. After a lamp-test, settings relative to current date and time will
be set to zero and default setting
gram will be restored.
All operating programs shall remain saved in the permanent memory of the device.
This same conditions occurs if the device is without power for a period exceeding the internal accumu-
lator charging reserve.
Re-enter the current date and time, choose the Standard Time to Daylight Saving Time switching pro-
gram, for reprogramming see paragraph 5.2
DISPOSAL OF OLD ELECTRICAL & ELECTRONIC EQUIPMENT (EU directive 2002/96/EC)
This symbol on the product or its packaging to indicates that this product shall not be treated as household waste.
Instead, it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment, such as for example:
- sales points, in case you buy a new and similar product
- local collection points (waste collection centre, local recycling center, etc...).
By ensuring this product is disposed of correctly, you will help prevent potential negative consequence for the environment and human health, which could otherwise be caused by
inappropriate waste handing of this product.
The recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local city office, your house hold waste
disposal service or the shop where you purchased the product.
Attention: in some countries of the European Union, the product is not included in the field of application of the National Law that applies the European Directive 2002/96/EC and therefore
these countries have no obligation to carry out a separate collection at the "end of life" of the product.
The manufacturer reserves the right to make all technical and manufacturing modifications deemed necessary without prior notice.
fully reprogram the entire time switch, simultaneously press
1 2 3 4 5 6 7
Ch 2 on the Standard Time to Daylight Saving Time switching pro-
; otherwise, time switch will not execute programs.
OK and PROG
This operation deletes all data saved in the time
switch, returning it to default conditions.
To fully reprogram the device, see paragraph 5.2.
and keep pressed
EN
1 2 3 4 5 6 7
Ok
Day 2
Y-M-Ch Y-M-Ch Delete
1 Prog
31