Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
13.2) Permanent manual forcing
During normal operation or temporary manual forcing conditions,
key
for 5 seconds.
1
Permanent forcing status is highlighted on the display by the appearance of the message
programs are inhibited (suspended). It is possible to change permanent channel (from
pressing key
. To return to normal programming operations, press key
1
programming at the end of the current minute.
1
5 SEC
1 2 3 4 5 6 7
1 2 3 4 5 6 7
14 - DELETING ALL ENTERED DATA
In normal operation, if you wish to
for 3 seconds.
After having performed the lamp-test cycle, the device will be ready for current hour entry.
Ok
Delete
Prog
3 sec.
1 2 3 4 5 6 7
15 - RESET OPERATION OR RESET WITH ACCUMULATOR DISCHARGED
Reset operations reset the time switch and are used for example upon initial start-up or if any anoma-
lies or malfunctions should be noted.
RESET
Lightly press
with a sharp object. After a lamp-test, settings relative to current hour and day will
be set to zero (weekly model only).
All operating programs shall remain saved in the permanent memory of the device.
This same conditions occurs if the device is without power for a period exceeding the internal accumu-
lator charging reserve. Re-enter the current hour and day, for reprogramming
erwise, time switch will not execute programs.
1
1 2 3 4 5 6 7
fully reprogram
the entire time switch, simultaneously press
1 2 3 4 5 6 7
1 2 3 4 5 6 7
channel permanent manual forcing
On
for 5 seconds
1
1
5 SEC
1 2 3 4 5 6 7
This operation deletes all data saved in the time
switch, returning it to default conditions.
To fully reprogram the device, see paragraph 5.2.
see paragraph 5.2
is obtained by pressing
.
During
permanent forcing
to
OFF
and vice-versa) by briefly
. The channel will return to normal
OK
and
PROG
and
keep pressed
1 2 3 4 5 6 7
Ok
Day
Delete
; oth-
1
Prog
, all
EN
27
Publicité
Chapitres
Table des Matières
