Manual Forcing Of Channel/S - Perry Electric 7080 Serie Mode D'emploi

14 - MANUAL FORCING OF CHANNEL/S (relays)
14.1) Temporary manual forcing
It is possible during normal operation to change channel/s status by pressing keys
lighted on the display by the appearance of a symbol
ample: if the forced channel was deactivated
ations, once again press keys
EN
1
1 2 3 4 5 6 7 1 2 3 4 5 6 7
14.2) Permanent manual forcing
During normal operation or temporary manual forcing conditions,
keys 1 or 2 for 5 seconds.
Permanent forcing status is highlighted on the display by the appearance of the message
programs are inhibited (suspended). It is possible to change permanent channel/s (from
pressing keys and/or
1
will return to normal programming at the end of the current minute.
1
5 SEC
1 2 3 4 5 6 7
30
near the channel symbol and charging status indication
OFF, it will then become
1 and/or 2 . The channel/s will return to the status found in normal programming operation.
2
1 2 3 4 5 6 7
. To return to normal programming operations, press keys
2
2
1 2 3 4 5 6 7
1 2 3 4 5 6 7
and/or
1
On and vice-versa). To return to normal programming oper-
Important:
each channel, is abandoned upon the first
1
switching of the channel itself (variation from
On to OFF
gramming being executed.
1 2 3 4 5 6 7
channel/s permanent manual forcing
On
or
1
1
1
5 SEC
1 2 3 4 5 6 7
1 2 3 4 5 6 7
. Temporary forcing status is high-
2
On or OFF
temporary manual forcing, for
and vice-versa) due to the pro-
is obtained by pressing
. During permanent forcing , all
to OFF and vice-versa) by briefly
for 5 seconds . The channel/s
2
(ex-