Before Startup; Operation - Kärcher BD 50/60 C Ep Classic Mode D'emploi

Operator console
1 OFF
Device is switched off
2 Normal mode
Wet clean the floor and vacuum up
dirt water.
3 Intense mode
Wet clean the floor and allow the
detergent to react.
4 Vacuum mode
Suck in the dirt fleet.
5 Program selection switch
6 Indicator light voltage supply
Glows when the mains plug is in-
serted and when there is mains
voltage.
Symbols on the machine
Mains plug
Lashing point
Mop holder **
Filling level fresh wa-
ter tank 25%
Bow brush change
Vacuum bar lowering
lever
Drain outlet fresh wa-
ter tank
Dirt water discharge
hose
** option

Before Startup

Unloading
 Unscrew the screws from the mid-
dle board of the pallet.
 Push down the device holding the
push handle and pull out the middle
board.
 Remove the chocks in front of and
next to the wheels.
 Push down the device holding the
push handle and push it forwards
up to the edge of the pallet.
 Lift the device off the pallet and set
it on the floor.
Installing the Vacuum Bar
 Insert the vacuum bar into the vac-
uum bar suspension in such a man-
ner that the profiled sheet is posi-
tioned above the suspension.
 Tighten the wing nuts.
 Insert the suction hose.

Operation

DANGER
Risk of injury!
In dangerous situations, release the
safety switch/drive lever.
Filling in detergents
Fresh water
 Open the lock of the fresh water
reservoir.
 Fill fresh water (maximum 60 °C)
until the lower edge of the filling
nozzle.
 Close the lock of the fresh water
reservoir.
Detergent
WARNING
Risk of damage. Only use the recom-
mended detergents. With other deter-
gents, the operator bears the in-
creased risk regarding the operational
safety and danger of accident.
Only use detergents that are free from
solvents, hydrochloric acid and hydro-
fluoric acid.
Follow the safety instructions for using
detergents.
Note:
Do not use highly foaming detergents.
Recommended detergents:
5
-
EN
Application
Routine cleaning of all
water resistant floors
Routine cleaning of
glossy surfaces (e.g.
granite)
Routine cleaning and ba-
sic cleaning of industrial
floors
Routine cleaning and ba-
sic cleaning of fine stone-
ware tiles
Routine cleaning of tiles
in sanitary areas
Cleaning and disinfection
in sanitary areas
Removal of coating from
all alkali-resistant floors
(e.g. PVC)
Removal of coating from
linoleum floors
 Add the detergent to the fresh water
reservoir.
Note:
If the fresh water tank is empty, the
cleaning head continues working with-
out liquid supply.
Setting the water quantity
 Adjust the water quantity using the
regulating button according to the
dirt on the floor covering.
Note:
Carry out initial cleaning attempts with
low water volume. Increase water vol-
ume step-by-step until the desired
cleaning result is achieved.
Setting the Vacuum Bar
Oblique position
To improve the vacuuming result on
tiled floors the vacuum bar can be
turned to an oblique position of up to
5°.
 Loosen the wing nuts.
 Turn the vacuum bar.
 Tighten the wing screws.
Inclination
If the vacuum result is unsatisfactory
the inclination of the straight vacuum
bar can be modified.
 Adjust the rotary handle to incline
the suction bar.
Detergent
RM 746
RM 780
RM 755 es
RM 69 ASF
RM 753
RM 751
RM 732
RM 752
RM 754
7