Initial Operation; Assembly Of The Additional Handle; Battery Pack - Metabo KHA 18 LTX BL 40 Notice Originale

packs. If necessary, consult your freight forwarder.
Certified packaging is available from Metabo.
Only send the battery pack if the housing is intact
and no fluid is leaking. Remove the battery pack
from the machine for sending. Prevent the contacts
from short-circuiting (e.g. by protecting them with
adhesive tape).
Reducing dust exposure:
WARNING - Some dust created by power
sanding, sawing, grinding, drilling, and other
construction activities contains chemicals known to
cause cancer, birth defects or other reproductive
harm. Some examples of these chemicals are:
- Lead from lead-based paints,
- crystalline silica from bricks and cement and other
masonry products, and
- arsenic and chromium from chemically treated
lumber.
Your risk from these exposures varies, depending
on how often you do this type of work. To reduce
your exposure to these chemicals: work in a well-
ventilated area, and work with approved safety
equipment, such as those dust masks that are
specially designed to filter out microscopic
particles.
This also applies to dust from other materials such
as some timber types (like oak or beech dust),
metals, asbestos. Other known diseases are e.g.
allergic reactions, respiratory diseases. Do not let
dust enter the body.
Observe the relevant guidelines and national
regulations for your material, staff, application and
place of application (e.g. occupational health and
safety regulations, disposal).
Collect the particles generated at the source, avoid
deposits in the surrounding area.
Use suitable accessories for special work. In this
way, fewer particles enter the environment in an
uncontrolled manner.
Use a suitable extraction unit.
Reduce dust exposure with the following measures:
- do not direct the escaping particles and the
exhaust air stream towards yourself or nearby
persons or towards dust deposits,
- use an extraction unit and/or air purifiers,
- ensure good ventilation of the workplace and keep
it clean using a vacuum cleaner. Sweeping or
blowing stirs up dust.
- Vacuum or wash protective clothing. Do not blow,
beat or brush protective gear.
5. Overview
See page 2.
1 LED light (worklight)
2 Additional handle
3 Wing screw (for adjusting the drill depth stop)
4 Drill depth stop
5 Dust protection cap
6 Tool lock
7 Metal eyelet (for fall protection)
8 Knob
9 Metabo VibraTech (MVT)
10 Button for continuous operation (only in chisel
operating mode)
11 Handle
12 Trigger
13 Button for reduced impact force (for working in
soft material)
14 Battery pack release button

15 Battery pack *

16 Capacity indicator button *
17 Capacity and signal indicator *
* equipment-specific

6. Initial Operation

6.1

Assembly of the additional handle

For safety reasons, always use the additional
handle (2) supplied.
Open the clamping ring by turning the additional
handle (2) anticlockwise. Secure the additional
handle at the required angle. Tighten the additional
handle.
6.2 Battery pack
Charge the battery pack (15) before use.
Recharge the battery pack if performance
diminishes.
The ideal storage temperature is between 10°C and
30°C.
In case of Li-Ion battery packs with capacity and
signal display (17) (equipment-specific):
- Press the button (16), the LEDs indicate the
charge level.
- The battery pack is almost flat and must be
recharged if one LED is flashing.
6.3 Removing and inserting the battery pack
Removing:
Press the battery pack release (14) button and
remove the battery pack (15).
Inserting:
Slide in the battery pack (15) until it engages.
7. Use
7.1 Depth Stop Setting
Release the wing (3) screw. Set the depth stop (4)
to the required drilling depth. Retighten the wing
screw (3).
7.2 Positioning, removing tool
Before inserting, clean tool shank and apply
supplied special grease (accessories: Order
no. 6.31800)! Use only SDS-max tools.
The dust protection cap (5) prevents the
ingress of drilling dust during operation. When
inserting the tool, pay attention to ensure that the
dust protection cap (5) is not damaged.
ENGLISH en
9