Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7
Replace the battery block on the Velcro strip.
3.3. Choice of location
Your immersion detector must be positioned in the center of the greatest length of your
swimming pool, on a coping (position recommended for rectangular swimming pools). If your pool
does not correspond to the configurations shown below, ask your retailer for advice.
Ensure that the central unit is more than one meter away from the filtration
system (return fittings, waste plug, skimmer, vacuum fittings, etc.) or waterfall or
any other device that may disturb the pool at this place.
Your immersion detector has been designed and configured in compliance with
standard NF P90-307/A1, and can be used in pools with maximum dimensions of
10 x 5 meters. Your immersion detector must not be further than 7 meters from
all possible fall locations.
If your swimming pool is larger, it must be fitted with several immersion detector.
Contact your retailer for advice.
In the case of a pool of a particular shape, ask your retailer for advice.
EXAMPLES:
Location of your central unit, for information only
I
Check that there is easy and practical access to the activation zone (where you place the magnet).
Max 7m
Location: any
6
8
Replace cover without tightening the screws.
Location: any
Publicité
Table des Matières
