Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3
Position the device at the location selected.
5
Check the immersion depth.
7
22cm
±
(
The immersion depth must be between 19 cm
and 25 cm (ideally 22 cm).
9
x5
Your device is in "off mode" , and must be
activated for the installation tests.
4
The rigid tube must be at least 5 mm
from the edge of the coping.
6
If your immersion depth is greater
than 25 cm, use a booster (book, flat stone,
brick, wooden board, etc.) which must not
destabilize the central unit.
8
3cm)
Carefully place a 2 to 3 kg weight on the device to
hold it in place.
Warning: for the first 30 minutes after
your device has been activated with
the magnet for the first time,
the siren sounds only for a short time,
at a low volume. You are in TESTS mode.
For more information on this mode, refer
to item 4.5.
8
5 mm mini
5 mm mini
Publicité
Table des Matières
