Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.3. Manual restart
1
2
3
4
After your swim, you can indicate to your immersion
detector that the pool is not being used, so that
monitoring is resumed faster.
You are then in one of the three situations described
below:
POOL VERY DISTURBED:
4 stages (steps 1 – 2 - 3 and 4)
POOL DISTURBED:
(steps 1 - 3 and 4)
STILL POOL:
restart in 2 stages (steps 1 and 4)
1
Move the magnet over the swimmer symbol
when leaving the pool.
2
Your immersion detector considers that your
pool is very disturbed. In this case, your device
acknowledges your request by emitting a short,
high-pitched beep, but cannot resume monitoring
immediately. Its
red
indicator light flashes.
DURING THIS TIME, YOUR POOL IS NOT
PROTECTED.
UTMOST VIGILANCE IS REQUIRED FROM
THE PARENT/RESPONSIBLE ADULT.
3
Your immersion detector considers that your
pool is disturbed. In this case, your device acknow-
ledges your request by emitting a short, high-pitched
beep. Its
green
and
red
turn. Your immersion detector will only detect
heavy falls, and will gradually resume full monitoring
of the pool.
DURING THIS TIME, UTMOST VIGILANCE IS
REQUIRED FROM THE PARENT/RESPONSI-
BLE ADULT.
4
Your immersion detector considers that your
pool is still. It resumes monitoring of the pool by
emitting a long, high-pitched beep. Its
light flashes.
YOUR POOL IS NOW PROTECTED
20
restart in
restart in 3 stages
indicator lights flash in
green
indicator
Publicité
Table des Matières
