4.4. Too much wind
In some cases, in the presence of rough weather conditions (strong wind, gusts of wind, etc.), your
immersion detector is likely to stop monitoring function. Its red indicator light flashes.
YOU MUST BE PARTICULARLY VIGILANT WHEN THE WEATHER IS ROUGH.
Warning: The performance as defined in standard NF P90-307/A1 is not guaranteed beyond
wind levels greater than those specified in this standard.
4.5. TESTS mode
In this mode, the siren sounds only for a short time, and at a low volume. This mode allows you to
perform the installation and monthly tests without disturbing you or the neighborhood.
The TESTS mode lasts for 30 minutes.
The start and stop of the TESTS mode are indicated by a specific tune.
x3
Manual start of the TESTS mode: red indicator light continuously on during the specific tune.
I
I
Manual end of the TESTS mode: green indicator light continuously on during the specific tune.
*Warning: When you place the magnet on the swimmer symbol, the device responds at first
as described in sections 4.1 "I want to have a swim" and 4.3 "Manual restart". You must keep
the magnet on this area to hear the loud beep and fast flashing of the red indicator light.
4.6. Off mode
In off mode, all your immersion detector's indicator lights are off.
You are reminded that the French act No. 2003-9 dated 3 January 2003 on swimming pool safety
requires that a device be installed permanently throughout the year.
Your retailer or AstralPool, or MG International cannot be held liable in the event of drowning after
the removal or complete stopping of your alarm system for whatever reason.
When your immersion detector is in off mode, vigilance by a person must imperatively
take over, or another standard safety system must be installed as an alternative.
To manually start and stop the tests mode, place
and keep the magnet on the swimmer symbol
until the loud beep is heard and until the red
indicator light flashes quickly.
Perform this operation 3 times in a row.*
21