Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
29
Your device is in "off mode" , and must be
activated for the validation tests.
WARNING: when your device switches out of TESTS mode (specific tune), the
siren of your immersion detector will sound at full volume. You can reactivate the
TESTS mode for an extra 30 minutes: to do this, please refer to item 4.5.
3.7. Validation tests
Make sure that the pool is still and that your immersion detector is monitoring (green indicator light
flashing). If such is not the case, move the magnet over the swimmer symbol:
If in spite of this, the indicator light does not switch to green, this means that the pool is not still
enough. You must imperatively wait until your pool is still before carrying out the tests.
You must wait for about ten minutes without handling the device in any way, and
with no disturbance in the pool, for your immersion detector to analyze its
environment and become stable (green indicator light). It is only after this time
that you will be able to perform the tests described below.
1
x1
Your immersion detector is in
armed mode (green indicator light flashing)
2
10 mn
Filtering working for 10 minutes,
your immersion detector is monitoring
(green indicator light flashing) and must not
set off the alarm..
15
Publicité
Table des Matières
