Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. Operating principle
How does Basic™ work?
The on-board technology of your immersion detector enables continuous monitoring of the pool.
In the event of a fall into the pool, your immersion detector sets off the siren in accordance with
the requirements of French standard NF P90-307/A1.
You must deactivate your immersion detector monitoring mode before having a swim. (Look up item 4.1)
After your swim, your immersion detector automatically resumes monitoring of the pool once it
has become still again. (Look up item 4.1)
The new Basic™ technology includes a continuous pool analysis system.
Basic™ signal principles:
General operation
STATUS
Your immersion detector is
monitoring
Your immersion detector is
not monitoring
Your immersion detector is
in partial monitoring mode
Your immersion detector is
switched off
Your immersion detector is
switching out of the TESTS
mode
Failure signals
STATUS
Low battery
Your immersion detector
has to be returned to the
after-sales service
SIGNALS
ACTION
With the magnet:
1 long, high-pitched beep
With the magnet:
5 short, high-pitched beeps
With the magnet:
1 short, high-pitched beep
(look up item 4.3)
With the 2 magnets:
15 short, high-pitched beep
(look up item 4.6)
Specific tune
(look up item 4.5)
SOUND SIGNALS
With the magnet
4 short, low-pitched beeps
3
VISUAL
flashing in turns
all indicator lights off
Periodic
1 short, low-pitched beep
every minute
2 short, low-pitched beeps
every minute
Publicité
Table des Matières
