Adjusting The Height Of The Integral Seat Belts - JANE GROOWY Mode D'emploi

fix anchors (24) with the slots in the armrests of the seat (16).
2
.f
• Press both sides of the handle to make sure that the anchors
have locked into place. The two Pro-fix indicators (27) should
2
be green. .g
• There is a cushion insert (15) for use with smaller children
(from 60 to 75 cm).
• The seat has ventilation windows.
• The seat can be reclined.
IN THE SAFETY SEAT (FROM 60 TO 105 CM)
• Fit the cushion insert (15) if necessary (from 60 to 75 cm).
• Loosen the integral seat belts by pulling the straps (5) above
the buckle while pressing the strap tightening button (5b).
• Unfasten the buckle (5a).
• Place the child in the seat making sure that he is sitting as far
back as possible and with his back upright. Bring the upper
ends of the buckle together.
• Insert them into the fastener and press until you hear them
2
click locked. .l
• Pull the tightening strap (5b). The correct strap tension is very
important for the child's safety, do not leave the straps too
2
loose. .m
IM 2111,01 GROOWY4 acordeo145x90 ES_EN_FR_DE_IT_PT.indd 29
2
.i
2
.k
I. ADJUSTING THE HEIGHT OF THE INTEGRAL
SEAT BELTS
The height of the shoulder straps should be adjusted as the
child grows. While the child is sitting in the seat, check that the
shoulder straps are in the right position. They should be slightly
above the child's shoulders. GROOWY, in this configuration, has 4
seat belt positions, as the strap height is adjusted the headrest
will move.
To adjust the height follow the steps below:
• Pull the lever found on the back of the headrest (4), this will
2
.j
unlock the headrest position.
• Move the headrest (3) to the right position for the child and
2
.h
release the lever. Move the headrest until you hear it click as
it locks into place. Pull the headrest to make sure that it is se-
curely locked in place.
!
IMPORTANT: Adjust this height as the child grows
Removing the seat when it is installed with ISOFIX:
• Release the ISOFIX anchors by pulling both release straps (7).
The signals on the front of the base (8) will turn red.
• Remove the seat. Press the ISOFIX anchors (6) to store them
inside the base.
EN 29
18/2/20 11:06