Installation Of The Booster Seat With Backrest With Isofix Anchors - JANE GROOWY Mode D'emploi

M. INSTALLATION OF THE BOOSTER SEAT WITH
BACKREST WITH ISOFIX ANCHORS
The booster seat with backrest can be installed with the ISOFIX
anchors, this gives the seat more lateral stability.
To install it follow the steps below:
• The ISOFIX anchors (6) are automatically extracted by firmly pu-
lling both the red rings (9) found on the front of the base.
• In some vehicles, the ISOFIX anchors are difficult to access or they
are hidden between the foam sections of the vehicle seat. With
the seat we have provided some guides (19) making it easier to
locate them, insert them before the following step.
• Guide the anchors towards the axles in your vehicle and press
until both sides are locked into place. Two green signals on the
front of the base (8) will show that they are securely anchored. If
one or both of the signals are red, try again.
• Lastly, press the base (1) against the backrest of the vehicle.
Adjusting the height of the headrest
• The height of the headrest is adjusted using the handle found
on the top part of the headrest at the back. To release the
lock pull the button upwards, when you release the button the
headrest will lock into the nearest position.
• Pass the lower lap part or the shoulder part of the vehicle
seat belt through the belt guide at the side of the headrest (11).
3
.l
IM 2111,01 GROOWY4 acordeo145x90 ES_EN_FR_DE_IT_PT.indd 31
• Position the child in the booster seat, and adjust the height
of the headrest using the button (4). The seat belt should be
slightly above the child's shoulder.
!
IMPORTANT: Adjust this height as the child grows
Placing the child in the seat
• Position the child in the booster seat and pass the vehicle shoul-
3
.e
der seat belt through guide at the side of the headrest (11).
• Pass the seat belt over the child and fasten the buckle
• Lastly, pass the belts under both armrests (10).
When you get the child out of the booster seat it is not necessary
to take the seat belt out of the guide at the side of the headrest
(11), this makes it easier to fasten the child in the next time the
booster seat is used.
3
.e
!
IMPORTANT: Even when the booster seat is not in use it
should be secured with the seat belt; in the event of an
accident or sudden braking it could get flung about and
injure the other occupants of the vehicle.
Removing the seat:
3
.k
• Release the ISOFIX anchors by pulling both the release straps
(7). The signals on the front (8) will turn red.
• Remove the seat. Press the ISOFIX anchors (6) to store them
inside the base.
3
.m
3
.l
EN 31
18/2/20 11:06