Unfolding And Folding; Using The Hood - JANE MICRO Instructions

1.- UNFOLDING AND FOLDING

Place the JANÉ MICRO folding carrycot on a flat surface.
Turn the ProFix system adaptor outwards. Remove the mat-
tress pad and push the spokes until you hear a click.
the upholstery inside the carrycot and place the mattress pad
on the bottom. 3-4 To fold it follow the same steps in reverse.

2.- USING THE HOOD

The hood of the JANÉ MICRO carrycot can be folded, unfold-
ed and taken off.
To fit the hood onto the JANÉ MICRO carrycot insert the hood
connector into the frame and fasten the rear zip.
move the hood, follow the same process in reverse.
3.- FOOT COVER
To open the foot cover of the JANÉ MICRO folding carrycot,
unfasten the clips on the top part.
16
1 To fasten the JANE MICRO carrycot onto a Jané chassis, place
the carrycot so that the child is positioned at the side oppo-
2 Fasten site the handlebar.
found on the armrests of the chassis, designed for this; it will
click into place when correctly fastened.
TAKE CARE! Before using it, make sure that all the locking
catches are closed.
To release the carrycot, pull the unlocking buttons on the
connectors upwards and separate the JANÉ MICRO folding
carrycot from the pushchair by pulling it upwards.
To improve the balance of your MICRO carrycot when it is
fitted onto your pushchair you can use the fastening system
following the instructions. Adjust the strap to tighten it.
5 To re-
- MUUM
- EPIC, RIDER, TRIDER
6
4.- FITTING ONTO A JANE PUSHCHAIR
7 Insert the Profix adaptors into the slots
8
9
WARNING: Unlock the system before removing the carrycot.
7A
7B