Changing The Position Of The Seat - JANE IKONIC Mode D'emploi

Extract the ISOfix anchors (6) by turning the handle (9) on
the side of the base. The anti-rotation leg (12) will unfold
due to IKONIC. 1 .a
Rear facing
Guide both anchors towards the connectors and press un-
til both sides are locked, two green signals on the base (8)
will show that both sides are correctly anchored. If one or
both of the signals are red, repeat this step. 1 .b
Turn the handle (9) anti-clockwise to fit the safety seat
firmly against the backrest of the vehicle seat. 1 .c
Pull the leg lock (12b) and extend it until it makes contact
with the floor of the vehicle. The signals on the foot of
the leg (12a) will turn green. 1 .d
Release the leg lock and extend the leg manually until it
locks again. The lock signal will turn green. 1 .e
F. CHANGING THE POSITION OF
THE SEAT
Forward facing
The IKONIC safety seat can be used in the rear facing
position from birth up to when the child is 105 cm tall or
in the forward facing position from 15 months up to when
the child is 105 cm tall.
The seat can be turned round 360°, the rotation only
35
EN
IM 2046_02_IKONIC alta.indd 35 10/7/18 10:20