Operation - Klarstein BLANCA Mode D'emploi

EN
22

OPERATION

Control panel and key functions
Press this button to turn the unit on and off.
Press repeatedly to adjust the flame brightness between 5 (high) and 1
(low). Press and hold the button for 5 seconds, then press repeatedly to
switch between flame colors (C1 - C7).
Press this button to switch between the different heating levels. The selected
level will be displayed on the heat level indicator. When the lower bar
is illuminated, the fire runs at low power (1000 W), when both bars are
illuminated, the fire runs at high power (2000 W).
Press and hold the button for 5 seconds, then press it repeatedly to set the
desired temperature from 1-35°C. The temperature will be set to 1-35°C.
An off timer can be set by repeatedly pressing the timer button while the unit
is running. The timer can be set from 0-9 hours in 30-minute increments.
A power-on timer can be set by repeatedly pressing the timer button while
the unit is in standby mode. The timer can be set from 0-9 hours in 30-minute
increments.
Press and hold the button for 5 seconds to turn off the week timer.
The display shows the room temperature as standard. When you make
certain settings, the display also shows the following
• the set flame brightness
• the set flame colour
• the set temperature