Use And Operation - Klarstein 10030846 Mode D'emploi

Control Panel and Remote Control
1 On/Off
2 Heater I
3 Flame+
4 Heater off
5 Heater II
6 Flame-
Buttons and Functions
Power
Heater off
Heater I/II
Flame
As an Important safety feature, the heating element Is designed with a delayed activation sequence. Therefore,
when the heater is turned on it will take several seconds for the unit to begin blowing hot air. Subsequently, the
fan blower will continue to run

Use and Operation

Press this button to turn the unit on. To turn it back to standby mode,
press it again.
This button will tum off the heater and blower.
This button will tum on the power to the heater and blower. The HEATER
switch has two options Heater I and Heater II. Hater I button will activate
the heater on the low setting (750 W). Heater II button will activate the
heater on the high setting (1500 W).
Allows you to adjust the flame to suit your mood. Press button [+] to in-
crease flame brightness and press [-] button to decrease flame brightness.
You must press the button [+] several times to see the full flame effect.
24